Product Review – SnapTable

Mark Young, president of Prime Roofing in Jacksonville, FL has found a very important tool for his metal roofing business. “In my experience, many contractors have difficulty properly hemming panels and keeping them straight, especially in the valleys. We found the SnapTable and it has addressed all the issues that we commonly were facing when prepping a metal roof panel for installation. In addition, prepping the panels by hand is time-consuming and difficult. The SnapTable allowed us to clip the ribs, slit the panel and hem the edge much quicker and more accurately than traditional methods."

“On a recent project, we needed over 300 panels and almost everyone required either a hip cut or valley cut or both,” continued Young. “Not to mention, the panels were 24-gauge steel. The idea of hand cutting and hemming all of those panels was mind-numbing. The SnapTable allowed us to prep our panels faster and more accurately than ever before.”

In fact, Young is encouraging other contractors to look into this time-saving tool. “Watch the videos online, crunch your numbers and you will see that this table works exactly like they say, actually better. The table is built very well and is incredibly strong. The notches will spit out a 1.5’’ 24-gauge rib like its nothing. On a recent 9,800 sq. ft. job we completed, we covered more than half the cost of our SnapTable with the labor savings.”

EDITORS NOTE: For more information about this product click HERE